Heat Gun On Composite Decking

The heat gun should never be less than 2 away from the deck surface and kept in continuous motion to avoid causing permanent damage or discoloration to the composite material.

Heat gun on composite decking. While composite decking is made from a blend of wood and plastic materials vinylPVC decking is most often 100 plastic. Sprayrinse each individual deck board using a fan tip no closer than 8-in 203 mm from the decking surface. My plans call for some elaborate curved trim pieces that really defined the style of the deck.

It has the upscale look homeowners crave has a legendary lifespan and never needs stained or painted as wooden decks do. DIY Heat Bending CompositePVC Deck Boards. Learn how to easily repair scratches or renew the surface of your composite decking from ZomeTek.

As long as you stick to the same guidelines as with composite decking and apply the pressure washer carefully it should work fine. In this way composite decking can be fairly unpredictable even within boards on the same deck. You want to practice this technique on some sample boards first because when you have an 850-degree heat gun and you hold it in place too long it will start to melt the board.

If the damage on a capped composite material is deeper than a mild scratch but does not fully penetrate the outer board capping a heat gun on a 450C setting can be used. Use a wire brush to scrape in the same direction of the grain while using the heat gun on the area. Spray deck with soap then follow by gently scrubbing each deck board with a soft bristle brush.

Theres some commercial systems for bending boards but I dont have access to them so I made my own strip heater. At the same time youll be using a wire brush to scrape the decking in the same direction as this scratch. Bending Composite Decking With Heatcon Heat Forming Kit.

Eco-friendly composite decking products made up of recycled plastics and reclaimed timber can conduct heat more readily than timber due to the plastic content. Composite decking has essentially replaced both wood and vinyl as the premier material for most new deck installations. You should lightly pass over the area where the distance of the heat gun nozzle should be around 10-15cm from the board surface but no closer when repairing the mark so as not to overheat the material.